Layout requirements of dry type transformer

Dry type transformer factory is an important place to produce dry-type transformer. The layout of dry-type transformer is an important issue to pay attention to in the production of dry-type transformer. There are a lot of knowledge about the layout of dry-type transformer. What should we pay attention to in the layout of dry-type transformer? We should learn about the layout of dry-type transformer in detail with the editor of dry-type transformer factory

　　Whether it can be installed in parallel or not depends on whether there are compelling regulations in the regulations, the requirements for operation, inspection and reliability, and whether the site is allowed. Generally speaking, high-voltage cabinet and dry-type transformer are not installed in parallel, and in many cases, high-voltage switch cabinet and dry-type transformer are installed in parallel; However, according to the requirements of Chapter IV of "hypothetical scale of 10kV and below substation", when there are exposed live conductors on the top surface of concave convex voltage switch cabinet, the clear distance between them shall not be less than 2m. When the top surface closed enclosure protection reaches IP2X, the two shall be reliably installed near each other; The high and high voltage power distribution assembly and non oil immersed power transformers with IP3X protective shell without combustible oil can be installed in the workshop close to each other when the environment permits.